2003 YAMAHA TTR 225 Maintenance Schedule

The following manuals is maintenance schedule for 2003 yamaha TT-R225. Perodic inspection, adjustment, and lubrication will keep your motorcycle in the safest and most efficient condition possible. Safety is an OBLIGATION of the motorcycle owner. The maintenance and lubrication schedule chart should be considered strictly as a guide to general maintenance and lubrication intervals. YOU MUST TAKE INTO CONSIDERATION THAT WEATHER, TERRAIN, GEOGRAPHICAL LOCATIONS, AND A VARIETY OF INDIVIDUAL USES ALL TEND TO DEMAND THAT EACH OWNER ALTER THIS TIME SCHEDULE TO SHORTER INTERVALS TO MATCH THE ENVIRONMENT. The most important points of motorcycle inspection, adjustment, and lubrication are explained in the following pages. PERIODIC MAINTENANCE/LUBRICATION

ITEM	REMARKS	BREAK-IN 1 month	EVERY
			6 months	12 months
Valve(s)*	Check clearance. Adjust if necessary	✔️	✔️	✔️
Spark plug	Check condition. Clean or replace if necessary.	✔️	✔️	✔️
Air filter	Clean. Replace if necessary.	every ride
Carburetor*	Check idie speed / starter operation. Adjust if necessary.	✔️	✔️	✔️
Fuel line	Check fuel for cracks or damage. Replace if necessary.		✔️	✔️
Engine oil	Replace (Warm wnginw before daining.)	✔️	✔️	✔️
Engine oil filter / Oils trainer*	Clean	✔️		✔️
Brakes*	Check operation / fluid leakage / See NOTE (Page 5-4) Correct if necessary.		✔️	✔️
Clutch*	Check operation. Adjust if necessary.		✔️	✔️
Rear arm pivot*	Check rear arm assembly for looseness. Tighten if necessary. Moderately repack. ***	✔️	✔️	✔️
Wheels*	Check balance, damage, runout and spoke tightness. Replace if necessary.		✔️	✔️
Wheel bearings*	Check bearing assemblies for looseness / damage. Replace if damaged.		✔️	✔️
Steering bearing*	Check bearing assemblies for looseness. Correct if necessary. Moderately repack every 24 months.**	Check		Check
Front forks*	Check operation / oil leakage. Repair necessary.		✔️	✔️
Rear shock absorver*	Check operation / oil leakage. Repair necessary.		✔️	✔️
Drive chain	Check chain stack / alignment. Adjust if necessary. Clean and lube.	Every ride (more often in wet or dusty areas)
Fittings / Fasteners*	Check all chassis fitting and fasteners. Correct if necessary.	✔️	✔️	✔️
Nuts and bolts	Check all nuts and bolts Retighten if necessary.	✔️	✔️	✔️
Sidestand*	Check operation. repair if necessary.	✔️	✔️	✔️

NOTE: 

Brake fluid replacement: 

1. When disassembling the master cylinder or caliper cylinder, replace the brake fluid. Normally check the brake fluid level and add fluid as required. 
2. On the inner parts of the master cylinder and caliper cylinder, replace the oil seals every two years. 
3.  Replace the brake hoses every four years, or if cracked or damaged.

Trending