Honda Pilot 2008-2012 Automatic Transmission Fluid Capacity

How to Check and Refill the Transmission Fluid in a 2010 Honda Pilot

Maintaining the proper transmission fluid level is essential for the smooth operation and longevity of your 2008-2012 Honda Pilot. This guide will walk you through the process of checking and refilling the transmission fluid to ensure your vehicle runs efficiently.

When to Service the Transmission Fluid

The transmission fluid should be drained and refilled with new fluid when prompted by the maintenance message on the information display or multi-information display, depending on your specific model. It is crucial to perform this service at the recommended intervals to prevent potential transmission issues.

Steps to Check the Transmission Fluid Level

1. Prepare the Vehicle:

   • Park the vehicle on a level surface.
   • Start the engine and let it run until the radiator fan turns on. This ensures that the engine is at normal operating temperature.
   • Turn off the engine and wait approximately 60 seconds (but no longer than 90 seconds) before proceeding to the next step.
     
     
     
     
     

2. Remove and Clean the Dipstick:

   • Locate the dipstick with the yellow loop on the transmission.
   • Remove the dipstick and wipe it clean with a cloth to ensure an accurate reading.
     
     
     
     
     

3. Check the Fluid Level:

   • Reinsert the dipstick fully into the transmission as shown in the illustration.
   • Remove the dipstick again and check the fluid level. The level should be between the upper and lower marks on the dipstick.

4. Refill if Necessary:

   • If the fluid level is below the lower mark, add Honda Genuine ATF-Z1 (automatic transmission fluid) through the dipstick hole.
   • Pour the fluid slowly and carefully to avoid spills. Clean up any spills immediately to prevent damage to engine components.
   • After adding fluid, recheck the level to ensure it is between the upper and lower marks.

5. Reinsert the Dipstick:

   • Insert the dipstick securely back into the transmission, ensuring the rubber cap fits properly into the dipstick guide.

Automatic Transmission Fluid Capacity

It is important to use the correct amount of transmission fluid during a fluid change. The specifications for the 2010 Honda Pilot are as follows:

• 2WD Models:

  • Change: 3.6 US qt (3.4 L)
  • Total Capacity: 8.6 US qt (8.1 L)

• 4WD Models:

  • Change: 3.6 US qt (3.4 L)
  • Total Capacity: 8.6 US qt (8.1 L)

Final Notes

Regularly checking and maintaining the correct transmission fluid level is a simple yet vital part of vehicle maintenance. Always use the recommended Honda Genuine ATF-Z1 fluid for your 2010 Honda Pilot to ensure optimal performance. If you notice any unusual transmission behavior, consider scheduling a service with a professional mechanic.

Trending